Headlights mocked up

Headlights in position to help work out position and geometry of new guard support brackets.

Front wings are "kinda" on.

Purists look away!
In order to get the guards to sit flat on the chassis rails, I had to cut a relief opening in the sides for the suspension to poke through. I'll fabricate some covers at a later date to close the holes in. In my defense, the hole I had to cut was no where near as big as the rust hole above it! That'll have to be patched as well. :) And yes, these are still the same original guards that were on the car when I got it.
The support bars that hold the guards square are soaking in the molasses at the moment and should be ready in about a week

Motor now in correct position.

I now have the motor resting at the correct height and ready to fabricate the engine and transmission mounts. The project is finally on the move again.

Rolling out for a little bit of sunshine

Work has been slow, but I was able to roll the Dodge out in the sun today. I wanted to turn it round so I could start setting the motor up in it properly. . . and yes. . . Cut the fire wall!
Seeing it in the sunshine has given me a little more ambition to get it up and happening.